login   |    register
A-Model [ MORE REVIEWS ] [ NEW STORIES ]

In-Box Review
1144
Antonov An-28
  • move

by: Is a secret [ JESSIE_C ]


Originally published on:
AeroScale

History
The AN- 28 was developed in the 1969 to replace the AN-14. It is similar in layout to the earlier design, but features an enlarged fuselage, turboprop powerplants and a larger wing to carry the increased payload. Production was allocated to Poland's PZL Mielec and did not begin until 1984 due to an unusually long development period. 68 of 191 An-28s remain in service and the design was adapted by PZL as the M-28 Skytruck in 1993.

First impressions
This is definitely an A-model kit. The tiny parts are a little rough, and will need to be cleaned up before assembly but much less than previous A-model offerings. Some of the smaller parts are decidedly out of scale, a limitation of the plastic. This kit does not include A-model's usual fret of etched parts, making it a little simpler than the preceeding AN-2. The panel lines are finely engraved and match up very nicely. In 1/144 this is a very small model.

Fuselage
The fuselage is two halves from nose to tail. The cabin windows are open, with clear parts provided for them. The cockpit windows are provided in two halves. Gluing them together will be slightly tricky due to their small size. A possible solution is to glue them into the fuselage halves before closing them. The panel lines are nicely engraved and match up well. A fairly complete cockpit is provided, with floor, bulkhead, seats and instrument panel. I don't know how much will be visible through the thick and distorting windows. By contrast to the AN-14 kit, a complete passenger cabin is provided. Little will be visible through the tiny windows. The kit will need nose weight but the correct amount is not indicated on the instructions. There is not much room in the nose for it. I suspect that the nose will end up packed full. There should be a pair of landing lights behind a clear fairing under the tip of the nose which are provided as a decal. It wil have to be scratchbuilt if the modeller wishes it to be clear, which will be challenging due to the small size. The lights are clearly visible in the picture of the Rodina aircraft linked to below. The rear fuselage freight/skydiving doors are moulded shut.

Wings
The wing is a one piece moulding that sits on top of a cradle moulded into the fuselage. Dry fitting and tweaking will be needed to ensure it fits squarely.

Empennage
The tailplane is another one piece moulding, completed with two fin/rudder mouldings that attach to each end.

Engines
The engines are two halves. One piece 3-bladed propellers attach to the engines without shafts. A little dryfitting will be needed to ensure correct allignment.

Landing gear
The landing gear struts and wheels are moulded seperately. The main struts fit onto the ends of stub wings that mount to the lower fuselage. Each main wheel is in two halves, as are the stub wings. The modeller is advised to tweak the fit in the same manner as was done with the wings to ensure everything is square. A wing strut is attached to each end of the stub wing, so it is vital that everything is in allignment in order for the struts to fit properly to the wing.

Accuracy
I don't compare models to drawings or published measurements. When assembled it will look like an AN-28.

Decals and markings
The decal sheet is in A-model's typical matte finish and offers two different An-28s. The first is from Poland's Sprint Airlines in overall white with a yellow nose and fins with a large blue S. The second is an overall white aircraft with blue trim from Russia's Rodina Air Service which is apparently a skydiving operation, as photos show the aircraft without its freight doors. There are sufficient decals to complete two aircraft.

The real thing
SP-DUB in service. This photo does not reproduce the colours properly; the yellow should be brighter, and the S graphic on the fins is actually blue rather than the black shown here.

RF-01196 departing on a wintry morning.

Please remember, when contacting retailers or manufacturers, to mention that you saw their products highlighted here - on AEROSCALE.
SUMMARY
Highs: The only An-28 in this scale.
Lows: Delicate parts mean that they can easily be broken or lost. No window decals, possibly not enough room for nose weight. Poor clear parts.
Verdict: This tiny little model will stretch your skills.
Percentage Rating
85%
  Scale: 1:144
  Mfg. ID: 1457
  Suggested Retail: C$24.99
  Related Link: 
  PUBLISHED: Nov 28, 2011
  NATIONALITY: Russia
NETWORK-WIDE AVERAGE RATINGS
  THIS REVIEWER: 90.12%
  MAKER/PUBLISHER: 80.63%

About Is a secret (Jessie_C)
FROM: BRITISH COLUMBIA, CANADA

Copyright 2019 text by Is a secret [ JESSIE_C ]. All rights reserved.



Comments

   

What's Your Opinion?


Photos
Click image to enlarge
  • move
  • move
  • move
  • move