login   |    register

135
Unboxing Takom's M9 ACE

  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move

About the Author

About Todd Michalak (TRM5150)
FROM: MASSACHUSETTS, UNITED STATES

I am building what I like, when I like and how I like it; having fun doing it. I have been building and finishing models on and off my whole life but the past ten years things really exploded. Just about anything goes when it comes to hitting the bench, but wrecked armor, rusted hulks, ships or ...


Comments

The only one I've found so far... and the corresponding TM drawing (from http://combatengineervehicle.tpub.com/TM-5-2350-262-10/ ) : and here's what the seat looks like : H.P.
JAN 15, 2016 - 09:37 PM
Since it solid plastic under the driver's copula, You'll have to cut a hole to get to the interior . I'm just going to put an half to 3/4 figure in mine and be done with it.
JAN 15, 2016 - 09:52 PM
Henry, thank you! That will help! Vince, Yea if there was one downside its that they covered the hatch, but otherwise still looks like a great kit!
JAN 16, 2016 - 12:05 AM
Thanks Todd, nice review and a very interesting subject.
JAN 16, 2016 - 03:24 AM
Hey fellas...thanks for the kind words about the review. I am snipping parts and just about ready to get a blog going for the build on this thing! A couple of small notes, I neglected to mention there is a suspension aligning tool (part A2)...keeps the swing arms straight in two of the three position options. Also, there are some ejector pin marks on the topside of the sponsons. The back half are unseen once the tractor is assembled, however, depending where the ejector's apron (sliding back wall) is located you may see one or two EPM's. They are shallow...quick fill and sand or just sanding will rectify all! Anything else crops up as I go, I will be sure to shout out! I'll try and get that blog started later this evening!
JAN 16, 2016 - 04:03 AM
Nice little kit; good review that makes me want to buy it !
JAN 16, 2016 - 01:33 PM
Excellent video, Todd.
JAN 16, 2016 - 09:28 PM
This kit just hit my front door and it is fantastic! Great review Todd.
JAN 16, 2016 - 09:38 PM
Thanks Dustin!! Thanks Matt! Nice box to hit the step!! Enjoy! I finally managed to get the blog up and running here on the Big A - LINK Stop by if you like and watch this one unfold!
JAN 17, 2016 - 01:43 AM
Everybody just needs to be patient, I'm sure a AM one is on the way.
JAN 17, 2016 - 04:05 AM